Flexus 100/200 - Pairing Flexus Sub

To pair the Flexus SUB 100 wireless subwoofer to the Flexus 100/200 sound bar, please follow the steps below.

1. Plug the power cable into the back of the subwoofer.
2. Plug in the USB transmitter into the sound bar.
   
3. The subwoofer should connect to the sound bar automatically. Once the subwoofer is paired to the sound bar, the Flexus SUB 100 will have a SOLID LED on the top. 

NOTE: If the speakers do not automatically pair to the sound bar, please use the instructions below for reconnecting the speakers to the sound bar. 

Reconnecting the Subwoofer

• Perform the following steps while the subwoofer and sound bar are plugged into power and turned on. 
• The Flexus 100/200 sound bar should have the USB transmitter connected. 

1. Hold the pair button, located on the back of the subwoofer, for 3-5 seconds.
2. The subwoofer's LED, located on the back of the subwoofer, will start to pulse. This indicates that the subwoofer is in "Pairing Mode."
3. Go back to the rear connections of the Flexus 100/200 (where you plugged the USB transmitter in), then push and hold the pair button for 3 seconds.
4. The status light on the Flexus SUB 100 should be solid, indicating it has successfully paired.