Flexus 100/200 - Pairing Flexus Surrounds

To pair the optional Flexus Surr 100 wireless surround speakers to the Flexus 100/200 sound bar, please follow the steps below.

1. Plug the power cable into the bottom of the surround speaker.
2. Plug in the USB transmitter that comes included with the Flexus Surr 100 into the sound bar.
   
3. The speaker should connect to the sound bar automatically. Once the surround speaker is paired to the sound bar, the surround speaker will have a SOLID LED on the bottom. 
   
   

NOTE: If the speakers do not automatically pair to the sound bar, please use the instructions below for reconnecting the speakers to the sound bar. 

Reconnecting the speakers

• Perform the following steps while the speakers and sound bar are plugged into power and turned on. 
• The Flexus 100/200 sound bar should have the USB transmitter connected. 

1. Hold the pair button, located on the bottom of the speakers, for 3-5 seconds. You will need to do this for both surround speakers. 
2. The speaker's LED, located on the bottom of the speakers, will start to pulse. This indicates that the speaker is in "Pairing Mode." Make sure both speakers show a pulsing LED indication before moving on to the next step. 
3. Go back to the rear connections of the Flexus 100/200 (where you plugged the USB transmitter in), then push and hold the pair button for 3-5 seconds.
4. The status light on the Flexus Surr 100 should be solid, indicating it has successfully paired.