Cinema 400 - TV Remote Programming

Will the Cinema 400 work with my TV remote?

How can I program my remote to work with my soundbar?

What buttons can I program to my bar?

If you want to use the TV remote to control the sound bar, you can program the sound bar to take certain commands from your TV remote. You can program the volume up, volume down, and power commands. Below, you will find the steps on how to program your TV remote to your Cinema 400 soundbar.

ATTENTION: These steps must be performed with a TV remote, not a cable (AT&T, DirecTV, Xfinity etc.) remote.

1. Press and hold the "Source" and "Volume Down" buttons simultaneously for 3 seconds
   
   
2. The source light will begin flashing to indicate that it is now in "remote programming mode"
3. On the front of the sound bar, press the button you wish to program once.
   • Note: The picture above shows the "Volume Up" being pressed so that it can be programmed. To program additional functions, press the button that corresponds with that function. For example, to program volume down, press the "Volume Down" button (on the sound bar) during this step.
     
     
     
4. The source light will then turn off
   
   
5. On the TV remote you are programming to the sound bar, press the button you wish to program once. Make sure that the remote is pointing directly at the sound bar within 12 inches.
   • Note: The picture above shows the "Volume Up" being pressed so that it can be programmed. To program additional functions, press the button that corresponds with that function. For example, to program volume down, press the "Volume Down" button (on the TV remote) during this step.
     
     
     
6. The source light will flash three times and then turn solid to indicate a successful button programming