Bar 48 - TV Remote Programming

Below, you will find the steps on how to program your TV remote to your Bar 48 sound bar. These steps must be performed with a TV remote, not a cable (AT&T, DirecTV, Xfinity etc.) remote.

Please Note: The "Volume Up" and "Volume Down" commands are the only programmable functions for this model

1. Press and hold the "Source" and "Volume Down" buttons simultaneously for 3 seconds
   
   
2. The source light will begin flashing to indicate that it is now in "remote programming mode"
3. On the front of the sound bar, press the button you wish to program once.
   • Note: The picture above shows the "Volume Up" being pressed so that it can be programmed. To program additional functions, press the button that corresponds with that function. For example, to program volume down, press the "Volume Down" button (on the sound bar) during this step.
     
     
4. The source light will then turn off
   
   
5. On the TV remote you are programming to the sound bar, press the button you wish to program once. Make sure that the remote is pointing directly at the sound bar within 12 inches.
   • Note: The picture above shows the "Volume Up" being pressed so that it can be programmed. To program additional functions, press the button that corresponds with that function. For example, to program volume down, press the "Volume Down" button (on the TV remote) during this step.
     
     
6. The source light will flash three times and then turn solid to indicate a successful button programming