Surround 3 - Pairing
Note: Please make sure the firmware is updated on the Bar 48 prior to pairing the Surround 3
- Plug in the Surround 3's to power them on
- Power off the Bar 48 by holding down the power button for 3 seconds
- Remove the end cap from the right side of the bar
- Insert the USB dongle that comes packaged with the Surround 3's into the USB slot hidden by the right side end cap
- Power the bar back on
- The ((SUR)) LED on the top of the bar should light up and the LED on the back of each of the surrounds should turn solid to indicate they're paired to the bar
- If the Surround 3's do not automatically pair, press and hold the "PAIR" button on the back of each surround, individually, for three seconds
- Note: You will see the status light on the back of the surround begin flashing, indicating it is in pairing mode
- Note: You will see the status light on the back of the surround begin flashing, indicating it is in pairing mode
- Once both surrounds are in pairing mode, move back to the right side of the sound bar and press and hold the "SURROUND PAIR" button for 3 seconds
Comments
0 comments
Please sign in to leave a comment.