RP-HUB1 - Firmware Update

Instructions

Please follow this procedure to ensure everything is updated correctly for firmware version 2.0.4.

1. Turn on the RP-HUB1 and wait on it to boot.
2. Press the MENU key on the remote, then select "Status," then "Speaker Status." Scroll right and make sure all speakers show a valid software version. If any of the speakers show 0.0.0, unplug those speakers for 30 seconds, then plug them back in. This prepares them for the software update.
3. Unzip the attached file and place the SbrUpdate.bin file in the root directory of a USB drive. Insert the USB drive and follow the prompts. Once it starts you will see a notice update started. The Screen will go blank and back on from time to time during the update. The Hub will reboot as well. You will be notified once the update is complete. This will also update the speakers to 1.1.9 which has a number of stability fixes.
4. When the update is complete (estimate about 5-6 minutes per speaker. Depending on your setup this could take anywhere from 10 to 60 mins), Press the MENU key on the remote, then select "Status," then "Speaker Status." Scroll to the right and make sure that all the speakers were updated to 1.1.9.

Firmware Update Attached