R-10B - TV Remote Programming

Below, you will find the steps on how to program your TV remote to your R-10B sound bar. Please note, these steps must be performed with a TV remote, not a cable (AT&T, DirecTV, Xfinity etc.) remote.

1. To put the sound bar in "programming mode", first make sure the source LED is Green. Press the source button all the way to the left (rectangle with an arrow going through it) until the LED is Green.
2. Press and hold the "Mute" button on the front of the sound bar until the source LED starts flashing yellow
   
   
3. With the source LED flashing yellow, press the button you wish to program on the front of the sound bar once. The source LED will turn solid Yellow.
   • Note: The picture above shows the "Mute" being pressed so that it can be programmed. To program additional functions, press the button that corresponds with that function. For example, to program volume down, you will press the "Volume Down" button (on the sound bar) during this step.
     
     
4. On the TV remote you are programming to the sound bar, press the button you wish to program once. Make sure that the remote is pointing directly at the sound bar within 12 inches.
   • Note: The picture above shows the "Mute" being pressed so that it can be programmed. To program additional functions, press the button that corresponds with that function. For example, to program volume down, you will press the "Volume Down" button 4 times slowly (on the TV remote) during this step.
5. After pressing the desired command on the TV remote four times slowly, you will see the source LED on the sound bar begin flashing green. The sound bar's LED will then turn solid Green, indicating a successful programming.