R-110SW - Amp Panel Removal

!!!WARNING!!!

Ensure amplifier is unplugged prior to proceeding any further

Tools Needed:

• #2 Philips Head Screwdriver
• Small Flat Blade Screwdriver

1.  Remove the 10 screws from around the perimeter of the amplifier panel
   
2. Once the screws have been removed, the amplifier panel will come free from the cabinet
   
3. Once the amplifier panel is removed from the cabinet, use a small flat blade screwdriver to release the wire clips holding the positive and negative terminals of the amplifier panel 
   
4. Next, disconnect the LED light cable from the amplifier panel
   
5. Once the amplifier panel has been removed, the subwoofer will appear as shown below
   
6. Reattach the wire clips from the woofer on to the new amplifier panel
7. Reattach the LED light cable to the new amplifier panel
8. Place the new amplifier panel back into position and replace the screws