KMC-1 - Battery Replacement & System Battery Reset

If you are having trouble with your battery charging or the unit powering up. Try doing a battery/system reset and see if it fixes the issue.

Tools Needed

• #2 Phillips Screwdriver

*Please make sure the USB charging cable is disconnected prior to opening the unit*

1. Flip the unit over and remove the 2 screws from the battery cover
   
   
2. Lift front edge of the battery cover to remove it, then set it aside
   
3. Flip the unit over to help remove the battery and pull it out
   
4. Gently pull out the battery cable until the connector emerges (circled in red)
   
   
5. Disconnect the battery by gently pulling apart the connector
   
6. Keep the battery disconnected for 30 seconds
7. Reconnect the battery cable
   
8. Feed and tuck the battery cable back into the unit
   
9. Once the cable is sufficiently tucked back inside the unit, slide the battery back into the compartment
   
10. Insert the tabs on the battery cover at an angle, then replace the 2 screws
    DO NOT OVER TIGHTEN